TM 9-2350-287-20-1
2-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION
ENGINES (STE/lCE) (continued).
a. STE/lCE PMCS - (continued).
(2) VTM CONNECTIONS AND CHECKOUT FOR TK.
WARNING
To prevent personal injury, do not connect
or disconnect VTM white engine is running.
CAUTION
Connect connector P1 of DCA cable W5 to
J1 on the VTM before connecting clip
leads to the battery.
I
Connect battery to VTM:
1. Pull VTM power switch to the OFF position.
2. Connect cable W5 connector P1 to VTM con-
nector J1.
3. Connect red clip lead to positive terminal of
battery and connect black lead to negative ter-
minal.
I
NOTE
Place the VTM so only its rubber feet touch
the vehicle or do all testing with the MASTER
switch ON. This will prevent sparking during
testing. Sparking will interrupt testing, but
will not damage the VTM.
I
A. 1. Push power switch on VTM to ON position.
2. Make sure VTM display shows “8.8.8.8” for
two seconds and then changes to’- -- -“.
Does VTM display show “8.8.8.8” and then change
to “- -- -“?
B. Make sure VTM display lights up.
Does display light up?
Continued on next page
2-386
