SLAVE STARTING DISABLED VEHICLE USING MAIN ENGINE (continued)

SLAVE STARTING DISABLED VEHICLE USING MAIN ENGINE (continued) - TM-9-2350-287-10_268

DRIVING OVER UNUSUAL TERRAIN - TM-9-2350-287-10_270

TM-9-2350-287-10 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
246

TM 9-2350-287-10 SLAVE STARTING DISABLED VEHICLE USING MAIN ENGINE (continued) 6. Attach slave cable (5) securely to slave receptacle (4) at each vehicle. 7. Turn MASTER switch to ON in operational M992A1. Set engine speed to 600 rpm. 8. Turn MASTER switch to ON in disabled vehicle. 9. Allow batteries in disabled vehicle to charge for 5 minutes before trying to start vehicle. 10. Try to start disabled vehicle. If it will not start, notify Unit maintenance. WARNING To prevent injury, make sure that MASTER switch Is turned to OFF in both vehicles before disconnecting slave cable. CAUTION To avoid damaging the charging system of the functioning vehicle, do not rev its engine above 600 rpm while slave starting another vehicle. NOTE It is not necessary to turn MASTER switches to OFF in both vehicles if both vehicles are M992A1 s. If slave starting any other vehicle, refer to that vehicle’s operator’s manual for slave starting. 11. After engine in disabled vehicle is running smoothly, turn MASTER switches OFF in both vehicles. 2-226

Privacy Statement
Press Release
Contact