SLAVE STARTING DISABLED VEHICLE USING MAIN ENGINE (continued)

SLAVE STARTING DISABLED VEHICLE USING MAIN ENGINE - TM-9-2350-287-10_267

SLAVE STARTING DISABLED VEHICLE USING MAIN ENGINE (continued) - TM-9-2350-287-10_269

TM-9-2350-287-10 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
245

TM 9-2350-287-10 SLAVE STARTING DISABLED VEHICLE USING MAIN ENGINE (continued) 2. Place shift lever (2) of each vehicle in neutral (N) position. 3. Turn ON MASTER switch in disabled vehicle and check to see if there is enough power to activate gages and interior lights. If not, refer to Charging Dead Batteries with the APU (p. 2-127). WARNING To avoid personal injury and vehicle damage, turn OFF MASTER switch and other electrical switches. 4. Turn MASTER switch (3) in each vehicle to OFF. NOTE It is not necessary to stop M992A1 main engine. It will continue to run with MASTER switch OFF. 5. Turn OFF all electrical switches in disabled vehicle. NOTE Only use slave receptacle in driver’s compartment of M992A1 for this procedure. 2-225

Privacy Statement
Press Release
Contact