TM 9-2350-287-10
PROJECTILE RACK OPERATION (continued)
5.
If right rack assembly is to be moved, remove right front double seat (p. 2-117).
6.
If left rack assembly is to be moved, remove two screws (8), lockwashers (7), and flat washers (9) from angle (6).
Remove angle (6) and spacer (5).
7.
Attach hoist (3) to trolley assembly (2).
NOTE
Snap hook back to the front.
8.
Lower hook of hoist (3) and secure it around lifting rod (10). Pull free end of chain to take up slack.
9.
Using 7/8-inch socket, 5-inch extensions, and hinged socket wrench handle, remove bottom connecting rods (11)
securing projectile rack assembly to floor.
10. Use hoist (3) to lift rack assembly until rack-mounting socket clears rack-restraint pins (12).
Before moving rack assembly toward rear of vehicle, make sure floor will provide a level resting place. If
floor Is not level rack may tip, causing injury or damage.
2-184
