TM 9-2350-287-10
OPERATING THE CONVEYOR (continued)
8. Position upper rear door (9) 45 degrees from closed position.
9. Install two quick-release pins (11) in two conveyor support struts (10), and tighten two
friction handles (12).
10. Disconnect short legs of two slings (8) from right side of conveyor (7).
11. Connect long legs of two slings (8) from right side of conveyor (7).
12. Raise upper rear door (9) just enough to take slack out of two slings (8).
13. Remove two quick-release pins (11) from two conveyor support struts (10). Loosen two
friction handles (12).
WARNING
• Before unlocking center hinges, operate upper rear door to
raise conveyor above horizontal. This will ensure that
conveyor clears the ground and operator's feet during
conveyor stowing.
• NEVER unlock center hinges unless slings are attached.
This will allow conveyor to collapse, causing damage or
serious Injury.
• Make sure travel path of upper rear door is clear of personnel
before opening door. Call out "CLEAR" when opening or
closing door to prevent personnel from stepping in front of
door.
14. Operate upper rear door (9) to raise conveyor (7) to horizontal (p. 2-138).
2-165
