TM 9-2350-277-34
REPLACE LOCKED-IN STUDS (M577A3 ONLY) Continued
0117 00
4.
If stud cannot be turned by hand, lock two jamnuts on nut end of stud. Then turn with a wrench.
NOTE
See Table 1, page 0117 00-3 for correct nut thread size.
5.
Remove jamnuts.
6.
If stud with serrated lockring is to be installed, place lockring on stud.
7.
Cut off a piece of heavy walled pipe or tubing to fit over stud as shown Step 8. See WP 0121 00 for fabrication
instructions.
0117 00-2