TM 9-2350-277-34
REPAIR FAN AND GENERATOR VARIABLE SPEED DRIVE — Continued
0115 00
21. Install new gasket (5) on rear housing (4).
22. Using.020-inch (.5-mm) shim stock and two 2-inch (51-mm) diameter hose clamps, compress three new rings on shaft.
Allow to seat for thirty minutes. Remove both clamps and shim stock.
23. Install front housing (3) on rear housing (4).
24. Install six screws (1) and washers (2) to secure front housing (3) to rear housing (4). TIGHTEN SCREWS TO 210-220
LB-IN (24-25 N m) TORQUE.
0115 00-11
