INSTALL NON-SKID RAMP KIT (M1064A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-34_579

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
492

TM 9-2350-277-34 INSTALL NON-SKID RAMP KIT (M1064A3 ONLY) 0085 00 THIS WORK PACKAGE COVERS: Prepare ramp (page 0085 00-1). Installation (page 0085 00-4). INITIAL SETUP: Maintenance Level Direct Support Tools and Special Tools General Mechanic’s Tool Kit (WP 0120 00, Item 62) Portable Electric Drill (WP 0120 00, Item 7) Pneumatic Hammer (WP 0120 00, Item 20) Electrical Disc Sander (WP 0120 00, Item 47) Screw Threading Set (WP 0120 00, Item 58) Materials/Parts Non-skid ramp kit P/N 10942588 Wood blocks, 6 x 6 x 12 inches (2) Personnel Required Track Vehicle Repairer 63H10 References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) INSTALLATION PREPARE RAMP 1. Place two wood blocks at rear of carrier. Position blocks so ramp and ramp door will rest on blocks when lowered. 2. Lower ramp (see your -10) onto blocks. 3. Remove ramp door handle stop (1). Discard stop. Use pneumatic hammer. 0085 00-1

Privacy Statement
Press Release
Contact