TM 9-2350-277-34
INSTALL NON-SKID RAMP KIT (M1064A3 ONLY) — Continued
0085 00
NOTE
All dimensions shown in the following illustration are in inches and metric equivalents.
Dimension tolerances are ± 1/16 inch (2 mm), unless otherwise indicated.
9.
Locate, drill, and thread mounting holes as explained in following illustration and text.
10. Place ramp non-skid plate on ramp to use as a template to locate five holes. Drill five holes with 27/64 inch (11 mm)
drill. Tap holes 1/2-13 UNC-2B to at least 1 inch (3 cm) deep. Use screw threading set.
11. Place ramp door non-skid plate on ramp door to use as a template to locate four holes. Drill four holes with 27/64 inch
(11 mm) drill. Tap holes 1/2-13 UNC-2B at least 1 inch (3 cm) deep. Use screw threading set.
12. Place new handle stop and new release bracket on ramp to use as template to locate five holes. Drill five holes with 5/16
inch (8 mm) drill. Tap holes 3/8-16 UNC-2B to at least 1 inch (3 cm) deep. Use screw threading set.
0085 00-3
