REPLACE DIODE AND MOTOR RESISTOR - TM-9-2350-277-34

FOLLOW-THROUGH STEPS - TM-9-2350-277-34_572

INSPECTION-ACCEPTANCE AND REJECTION CRITERIA - TM-9-2350-277-34_574

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
486

TM 9-2350-277-34 REPLACE DIODE AND MOTOR RESISTOR 0083 00 THIS WORK PACKAGE COVERS: Removal (page 0083 00-1). Inspection-Acceptance and Rejection Criteria (page 0083 00-2). Installation (page 0083 00-3). INITIAL SETUP: Maintenance Level Direct Support Tools and Special Tools Automotive Fuel and Electrical System Repair Tool Kit (WP 0120 00, Item 59) Digital Multimeter (WP 0120 00, Item 38) Metric Wrench Kit (WP 0120 00, Item 77) Personnel Required Fuel and Elec Sys Rep 63G10 References See your -20 Equipment Condition Engine coolant heater removed fromcarrier (see your -20) REMOVAL 1. Remove four screws (1) and guard (2) from heater (3). NOTE Note direction of arrow on diode so it can be installed later. 2. Remove diode (4) from holder (5). 3. Remove motor resistor (6) leads from terminals No. 4 and No. 6 on terminal board (7). 0083 00-1

Privacy Statement
Press Release
Contact