INSTALLATION - TM-9-2350-277-34

REPLACE FIXED RESISTOR - TM-9-2350-277-34_569

REPLACE BURNER PACKING AND GASKET - TM-9-2350-277-34_571

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
483

TM 9-2350-277-34 REPLACE FIXED RESISTOR — Continued 0081 00 6. Use multimeter (16). Check resistance from circuit 7 terminal end (17) to strap end (18) of fixed resistor (11). 7. Multimeter should read 1.6 to 1.7 ohms. If reading is not in range, replace fixed resistor. INSTALLATION 1. If fixed resistor (11) is to be replaced, grind or cut sleeve (12) off of fuel tube (9). Discard sleeve. 2. Install fixed resistor (11) and new sleeve (12) on fuel tube (9). 3. Secure electrical lead (15) to fixed resistor (11) with screw (14) and nut (13). 4. Secure fixed resistor (11) to heater (3) with nut (10). 5. Secure fuel tube (9), flange (8), and tapping plate (7) to heater (3) with two screws (6). 6. Install end cover (5) on heater (3). Tighten four nuts (4). 7. Secure fuel control valve bracket (2) to heater (3) with two screws (1). FOLLOW-THROUGH STEPS 1. Install engine coolant heater in carrier (see your -20). END OF TASK 0081 00-2

Privacy Statement
Press Release
Contact