MODIFY - TM-9-2350-277-34

REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064A3 ONLY)

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
362

TM 9-2350-277-34 REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064A3 ONLY) — Continued 0065 00 3. Remove cylinder (3) from anchor (4). 4. Remove anchor (4) and all weld material from hull bottom plate. Discard anchor. MODIFY 1. Grind weld area level and smooth. 2. Locate center of first hole as shown. NOTE Drill all holes straight and at right angles to hull bottom plate. 3. Drill first hole with 7/16 inch (11 mm) diameter drill. Bottom plate is 1-1/8 inches (3 cm) thick. Do not break through. 4. Tap first hole with a 1/2-13UNC tap to a minimum thread depth of 7/8 inch (22 mm). 0065 00-2

Privacy Statement
Press Release
Contact