REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064A3 ONLY)

CHAPTER 13 DIRECT SUPPORT MAINTENANCE INSTRUCTIONS FOR HYDRAULIC SYSTEM

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
361

TM 9-2350-277-34 REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064A3 ONLY) 0065 00 THIS WORK PACKAGE COVERS: Remove (page 0065 00-1). Modify (page 0065 00-2). Install (page 0065 00-5). INITIAL SETUP: Maintenance Level Direct Support Tools and Special Tools General Mechanic’s Tool Kit (WP 0120 00, Item 62) Portable Electric Drill (WP 0120 00, Item 7) Twist Drill Set (WP 0120 00, Item 9) Pneumatic Hammer (WP 0120 00, Item 20) Electrical Disc Sander (WP 0120 00, Item 46) Torque Wrench (WP 0120 00, Item 73) Materials/Parts Adhesive primer (WP 0122 00, Item 23) Anchor Cotter pin Screw Washer Screw Personnel Required Track Vehicle Repairer 63H10 References See your -10 See your -20 TM 9-1015-232-23&P TM 43-0139 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Mortar removed (see your -10) Mortar turntable and ring gear removed (TM 9-1015-232-23&P) REPAIR OR REPLACEMENT REMOVE 1. Remove cotter pin (1). Discard pin. 2. Remove headed pin (2). Retain pin. 0065 00-1

Privacy Statement
Press Release
Contact