REPAIR OR REPLACEMENT - TM-9-2350-277-34

REPAIR FRONT AND REAR TRIM VANE FLOTATION PODS

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
287

TM 9-2350-277-34 REPAIR FRONT AND REAR TRIM VANE FLOTATION PODS — Continued 0046 00 CAUTION Holes in plastic molding material are allowed on surfaces and edges to 1/2 inch (13 mm) maximum depth. All holes combined must not exceed 6 cubic inches (98 cubic centimeters) to keep trim vane buoyant. 2. Remove damaged plastic molding material from pod (1) or (2) with a putty knife. 3. Fill damaged areas with plastic molding material. FOLLOW-THROUGH STEPS 1. Install flotation pods on trim vane (see your -20). END OF TASK 0046 00-2

Privacy Statement
Press Release
Contact