TM 9-2350-277-34
REPAIR WATER BARRIER — Continued
0045 00
4.
Rivet as necessary using rivet bucking bar and ball peen hammer.
5.
If strap (3) is unserviceable, remove by grinding off head of rivet (4) and punch out remainder of rivet. Remove and
retain washer (5). Discard strap and rivet.
6.
On new strap (3) measure from buckle 3 1/2 - 4 inches (8.9 –10.2 cm) towards strap tip and punch a hole with a rivet
cutting punch 3/16 inch (4.76 mm) size in the center of the strap.
7.
Position strap (3) on plate (6). Insure the holes on straps align with holes on plate.
8.
Install washer (5) and rivet (4) on strap (3). Secure rivet, washer and strap to plate, using rivet bucking bar and ball
peen hammer.
0045 00-2
