REPLACE FRONT MAIN WIRING HARNESS Continued

REPLACE FRONT MAIN WIRING HARNESS Continued - TM-9-2350-277-34_244

REPLACE FRONT MAIN WIRING HARNESS Continued - TM-9-2350-277-34_246

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
201

TM 9-2350-277-34 REPLACE FRONT MAIN WIRING HARNESS — Continued 0030 00 20. Connect circuit 75A (10), 75B (11), 366 (12), 366A (13) leads to stop switch (14). 21. Connect connector (19) to dimmer switch (20). 22. Install cover (21) on harness (22). Route harness through cover opening (23) into power plant compartment. Secure cover on driver’s compartment bulkhead with four screws (24) and new locknuts (25). 23. Slide mount plate (1) between two lower lockwashers (2), two upper lockwashers (3), and screws (4) of voltage regulator (5). 24. Slide two new lockwashers (6), under front mount plate (1) on hull weld nuts. Place two new lockwashers (7) on mount plate (1) over holes. Secure with two screws (8). 0030 00-25

Privacy Statement
Press Release
Contact