INSTALLATION-cont. - TM-9-2350-277-20-5

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-5_794

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
668

TM 9-2350-277-20-5 REPLACE NBC CABLE TO HEATERS, AIR PURIFIER, AND SWITCH ASSEMBLY (M113A3 ONLY) — Continued 0800 00 INSTALLATION 1. Position NBC cable assembly in vehicle. 2. Install screw (27) lockwasher (28) and ground lead (29) to bracket (26). WARNING Removing cables from the regulator without disconnecting the vehicle battery ground cable may hurt personnel and damage equipment from electrical power. 3. Install four screws (23), lockwashers (24), and regulator (25) to bracket (26). 4. Connect cable connector (30) to NBC control box (31). 5. Install circuit 10 lead (22) on connector (14). 6. Install circuit 10A lead (19) on connector (21) and circuit breaker (21). 7. Install circuit 579A lead (13) on connector (14). 8. Install circuit 537B lead (15) to driver’s heater controller lead (16). 9. Install circuit 537A lead (17) to commander’s heater controller lead (18). 10. Install circuit 579C lead (6) to jack (7) on air filter switch (8). 11. Install circuit 537C (9) to jack (10) on air filter in lamp (11). 12. Install NBC cable (1) on air purifier (2). 13. Install cover (4) between the switch assembly (5) and transverse beam. Tighten two screws (3) to secure switch (5) and cover (4) to transverse beam. 0800 00-3

Privacy Statement
Press Release
Contact