TM 9-2350-277-20-5
REPLACE M13 NBC HEATER HOSES (M1068A3 ONLY) — Continued
0790 00
7.
Install forward operator’s inlet hose (1) and two clamps (2) on forward operator’s heater (3) and manifold (4). Tighten
clamps.
8.
If bracket (5) was removed, install bracket on table supports with two screws (6), new lockwashers (41), four washers
(7), and two nuts (8).
9.
If any of three brackets (9) was removed, install bracket (9) on bracket (5) with two screws (10), four washers (11), two
new lockwashers (40), and nuts (12).
10. Install forward operator’s outlet hose (13) and clamp (14) on connector (15) and forward operator’s heater (3). Tighten
clamp.
11. If grommet (16) was removed, install new grommet on commander’s inlet hose (17). Route hose through welded frame
and insert grommet.
12. Install commander’s inlet hose (17) and two clamps (18) on commander’s heater (19) and manifold (4). Tighten clamps.
0790 00-6
