TM 9-2350-277-20-5
REPLACE M13 NBC HEATER HOSES (M1068A3 ONLY) Continued
0790 00
INSTALLATION
1.
Install rear operators inlet hose (14) and two clamps (18) on rear operators heater (4) and manifold (19). Tighten
clamps.
2.
Install two clamps (17) on rear operators inlet hose (14) Secure clamps on sponson with two screws (15) and new
lockwashers (16).
3.
Secure electrical leads to rear operators inlet hose (14) with new straps (13).
4.
If bracket (9) was removed, install bracket on table supports with four screws (10), washers (11), and new
lockwashers (12).
5.
If either bracket (5) was removed, install bracket (5) on bracket (9) with two screws (6), washers (7), new lockwashers
(20), and nuts (8).
6.
Install rear operators outlet hose (2) and two clamps (1) on connector (3) and rear operators heater (4). Tighten clamps.
0790 00-5