REPLACE M13 NBC HEATER HOSES (M1068A3 ONLY)

INSTALLATION-cont. - TM-9-2350-277-20-5_728

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
609

TM 9-2350-277-20-5 REPLACE M13 NBC HEATER HOSES (M1068A3 ONLY) 0790 00 THIS WORK PACKAGE COVERS: Removal (page 0790 00-1). Installation (page 0790 00-5). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Grommet (2) Locknut (2) Locknut (4) Locknut (10) Lockwasher (4) Lockwasher (4) Lockwasher (6) Strap (as required) Personnel Required Unit Mechanic References See your -10 see TM 3-6680-316-10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Battery ground lead disconnected (WP 0338 00) REMOVAL 1. Loosen clamp (1) on driver’s outlet hose (2). Remove hose from connector (3) and driver’s heater (4). 2. If bracket (5) is damaged, remove two screws (6), lockwashers (20), washers (7), and bracket from driver’s bulkhead. Discard lockwashers. 3. Remove screw (8), two washers (9), one locknut (10), and clamp (11) from welded bracket. Remove clamp from driver’s inlet hose (12) and commander’s inlet hose (13). Discard locknut. 4. Remove screw (14), lockwasher (15), and clamp (16) from sponson. Remove clamp from driver’s inlet hose (12) and commander’s inlet hose (13). Discard lockwasher. 5. Loosen two clamps (17) on driver’s inlet hose (12). Remove hose from heater (4) and manifold (18). 0790 00-1

Privacy Statement
Press Release
Contact