TM 9-2350-277-20-5
REPLACE SMOKE GENERATOR GLOW PLUG CABLE ASSEMBLIES (M1059A3 ONLY) —
Continued
0772 00
NOTE
There are two exterior cables, access plates, and smoke generators, left and right. Cables are
removed from vehicle the same way. Only one exterior cable, access plate, and smoke generator
is shown. Remove cables as required.
3.
Disconnect exterior cable (5) from interior cable (4) in left access plate (6).
4.
Disconnect exterior cable (5) from preheat harness jack (7) on panel (8) of left smoke generator (9).
5.
Remove screw (1), lockwasher (2), and clamp (3), and interior cable (4) from right side of hull. Discard lockwashers.
6.
Disconnect exterior cable (5) from interior cable (4) in right access plate (6).
7.
Disconnect exterior cable (5) from preheat harness jack (7) on panel (8) of right smoke generator (9).
8.
Remove four screws (10), locknuts (11), and interior cable (4) from right access plate (6). Discard locknuts.
9.
Remove four screws (10), locknuts (11), and interior cable (4) from left access plate (6). Discard locknuts.
0772 00-3
