INSTALLATION - TM-9-2350-277-20-5

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-5_631

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
523

TM 9-2350-277-20-5 REPLACE SMOKE GENERATOR GLOW PLUG CABLE ASSEMBLIES (M1059A3 ONLY) — Continued 0772 00 INSTALLATION NOTE There are two exterior cables, access plates, and smoke generators, left and right. Cables are installed on vehicle the same way. Only one exterior cable, access plate, and smoke generator is shown. Remove cables as required. 1. Install interior cable (1), four screws (2) and new locknuts (3) to right access plate (4). 2. Connect exterior cable (5) to preheat harness jack (6) on panel (7) of right smoke generator (8). 3. Connect exterior cable (5) to interior cable (1) in right access plate (4). 4. Install interior cable (1), four screws (2) and new locknuts (3) to left access plate (4). 5. Connect exterior cable (5) to interior cable (1) in left access plate (4). 6. Connect exterior cable (5) to preheat harness jack (6) on panel (7) of left smoke generator (8). 0772 00-4

Privacy Statement
Press Release
Contact