REPLACE SMOKE GENERATOR ARMOR (M1059A3 ONLY)

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
517

TM 9-2350-277-20-5 REPLACE SMOKE GENERATOR ARMOR (M1059A3 ONLY) 0771 00 THIS WORK PACKAGE COVERS: Removal (page 0771 00-1). Installation (page 0771 00-2). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Torque Wrench (WP 0926 00, Item 84) Suitable Lifting Device Materials/Parts Locknut (3) Lockwasher Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Decontamination can removed (right side only) (see your -10) Smoke generator fuel filter/water separator removed (WP 0773 00) REMOVAL WARNING You could be killed or injured by accidental carrier movement. Before you perform maintenance make sure to properly block the carrier. Do not stand under suspended heavy objects. Keep hands away from pinch points. 1. Remove inboard armor shield. a. Remove two screws (1) and washers (2) from two angle brackets (3) at top of inboard armor shield (4). b. Lower shield (4). c. Remove three screws (5), locknuts (6), six washers (7), and inboard shield from three hinge assemblies (8). Discard locknuts. d. Remove four screws (9) and washers (10) securing two angle brackets (11) and shims (12) to shield (4). e. Remove six screws (13) flat washers (14) securing three hinges (8) and shims (15) to hull. 0771 00-1

Privacy Statement
Press Release
Contact