REPLACE SMOKE GENERATOR ADAPTER ACCESS PLATE AND GASKET (M1059A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-5_605

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
503

TM 9-2350-277-20-5 REPLACE SMOKE GENERATOR ADAPTER ACCESS PLATE AND GASKET (M1059A3 ONLY) 0766 00 THIS WORK PACKAGE COVERS: Removal (page 0766 00-1). Installation (page 0766 00-3). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Locknut (4) Lockwasher (6) Personnel Required Signal Support System Specialist 31U10 References See your -10 TM 3-1040-283-10 TM 3-1040-283-20 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Circuit breaker CB1 OFF (TM 3-1040-283-10) Battery ground strap disconnected (WP 0337 00) Air pressure released from compressor reservoir (TM 3-1040-283-20) Inboard armor shield lowered (WP 0771 00) Smoke generator assembly removed from bracket (WP 0755 00) REMOVAL WARNING Compressed air pressure from smoke generator can cause serious injury or death. To avoid accidents, bleed air before working on air compressor assembly or disconnecting any air hose. WARNING Before you do any maintenance, discharge all capacitors to ground or electrical shock could injure personnel. NOTE Left and right access plates and gasket are replaced the same way. 1. Disconnect air hose (1) and fog oil hose (2) from two elbows (3). 0766 00-1

Privacy Statement
Press Release
Contact