TM 9-2350-277-20-4
REPLACE HORIZONTAL AMMUNITION RACK (M1064A3 ONLY) — Continued
0606 00
2.
Install two screws (2), washers (3), vertical posts (4) on sponson.
NOTE
Start installation of 18 screws inside hull from top and work down. Rack mounting holes may
be elongated to 3/16 inch to match hole pattern.
3.
Install 18 screws (5) and washers (6) in rack assembly (1) and side hull.
4.
Position two brackets (7) against hull top plate and top of rack (1). Install four screws (8) and washers (9) in brackets (7)
and hull top plate. Close all ammo doors.
FOLLOW-THROUGH STEPS
1.
Start engine (see your -10).
2.
Raise and lock ramp (see your -10).
3.
Stop engine (see your -10).
END OF TASK
0606 00-3/4 blank
