TM 9-2350-277-20-4
REPAIR NONSKID SURFACES (M981A3 ONLY)
0605 00
THIS WORK PACKAGE COVERS:
Cleaning (page 0605 00-1).
Painting (page 0605 00-2).
Apply Nonskid(page 0605 00-3).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Cleaning compound (WP 0928 00, Item 17)
Coating compound (WP 0928 00, Item 21)
Corrosion kit (WP 0928 00, Item 23)
General purpose detergent (WP 0928 00, Item 35)
Lacquer thinner (WP 0928 00, Item 40)
Paint brush (WP 0928 00, Item 44)
Primer coating (WP 0928 00, Item 45)
Walkway compound (WP 0928 00, Item 63)
Wiping rag (WP 0928 00, Item 65)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
CLEANING
1.
Area to be repaired must be clean. The cleaning method will depend on the type and amount of contamination as defined
in the following steps.
2.
For light contamination, clean area with mild solution of detergent and fresh water. Rinse with clear fresh water and
wipe dry with a wiping rag.
3.
If area contains organic soil, clean with cleaning compound. Follow cleaning compound instructions in Step 4.
WARNING
Cleaning compound vapors are toxic. Use compound only in a well ventilated area. Do not
breath vapors. Avoid contact with skin. Respiratory protection and skin protection is required.
4.
If area contains inorganic soil, scrape or brush first, to remove heavy buildup. Then clean with cleaning compound as
follows:
a.
Cleaning compound must be mixed with water. Do not use undiluted cleaning compound. Depending on the type
of cleaning required, mix one part of cleaning compound with water as follows:
Heavy cleaning — 4 parts water
Normal cleaning — 9 parts water
Light cleaning — 16 parts water
b.
Rinse all areas to be cleaned with fresh water.
0605 00-1
