TM 9-2350-277-20-4
REPLACE ROAD WHEEL SUPPORT ARM, BEARINGS, AND SEALS — Continued
0415 00
9.
Install new packing (1) on housing (2).
10. Secure guard (3), packing (1), and road wheel support arm housing (2) to hull (number four and five positions) with four
screws (4) and two screws (5). TIGHTEN SIX SCREWS TO 130-140 LB-FT (176-190 N•m) TORQUE.
11. Secure guard (3), packing (1) and road wheel support arm housing (2) to hull (number three position) with four screws
(4) and two screws (5). TIGHTEN SIX SCREWS TO 130-140 LB-FT (176-190 N•m) TORQUE.
12. Secure assembled road wheel support arm (6) and packing (1) to hull (number one and two positions) with six screws
(5). TIGHTEN SCREWS TO 130-140 LB-FT (176-190 N•m) TORQUE.
FOLLOW-THROUGH STEPS
1.
Install torsion bar (WP 0413 00).
2.
If removed, install shock absorber (WP 0435 00).
3.
Install road wheel hub (WP 0416 00).
4.
Install road wheel (WP 0426 00).
5.
Install track shroud and covers (WP 0438 00).
6.
Unblock carrier (see your -10).
7.
Road test carrier to check that arm is installed right (WP 0155 00).
END OF TASK
0415 00-6
