TM 9-2350-277-20-4REPLACE DRIVER’S HATCH HOLD-OPEN HOOK AND BUMPER (M113A3, M1059A3,M1064A3, AND M58 ONLY) — Continued0532 00NOTEInstall washer(s), as needed, to compress bumper 1/4 inch (6 mm) when hold-open hook isengaged.2. Install washer(s) (14) and bumper (13) in hull top plate. From inside carrier, secure with washer (12) and nut (11).3. Place block (1) on hull bracket (2). Secure with two screws (3), four washers (4), and two new locknuts (5).4. Install S-hook (6) in safety pin (7) and chain (8). Squeeze both ends of S-hook to secure.5. Install tube (9) on chain (8).6. Install S-hook (10) in chain (8) and on hull bracket (2). Squeeze both ends of S-hook to secure.FOLLOW-THROUGH STEPS1. Open and close driver’s hatch cover and engage hold-open hook to check that hook and bumper are installed correctly.END OF TASK0532 00-3/4 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
