INSTALLATION - TM-9-2350-277-20-4

REPLACE DRIVERS HATCH HOLD-OPEN HOOK AND BUMPER (M113A3, M1059A3, M1064A3, AND M58 ONLY)

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
407

TM 9-2350-277-20-4 REPLACE DRIVER’S HATCH COVER AND EXTERIOR LOCK (ALL EXCEPT M901A3 AND M981A3) — Continued 0531 00 3. Place new seal (7) over retaining groove in cover (8) and press seal into place. Trim end, if needed. 4. Install screw (9) in cover (8) and secure with new locknut (10). 5. Align cover (8) with hinge brackets and install two fiber washers (11) and shield (12). 6. Apply light coat of grease to each spring (13). Install springs in shield (12). 7. Place cover (8) in vertical position and install retainer (14) on hinge brackets. Secure with two screws (15) and new locknuts (16). FOLLOW-THROUGH STEPS 1. Install driver’s hatch periscope quick release assembly. 2. Install driver’s hatch periscope guard (WP 0536 00). 3. Connect driver’s hatch interior latch to cover (WP 0534 00). END OF TASK 0531 00-4

Privacy Statement
Press Release
Contact