ADJUST RAMP LOCK (M1064A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-4_451

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
366

TM 9-2350-277-20-4 ADJUST RAMP LOCK (M1064A3 ONLY) 0523 00 THIS WORK PACKAGE COVERS: Adjustment (page 0523 00-1). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Cotter pin Flat steel washer (as needed) Key washer (8) Lockwasher (2) Personnel Required Unit Mechanic Helper (H) References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) ADJUSTMENT WARNING Falling ramp could cause severe injuries. Keep personnel clear of ramp area. 1. Lower ramp (see your -10). 2. Remove cotter pin (1) and headed pin (2) from clevis (3). Discard cotter pin. 3. Disconnect link (4) from clevis (3). 4. Swing lever (5) forward. If catch (6) does not engage with striker (7), adjust catch (Step 5). If catch and striker adjustment is all right, go to Step 7. 0523 00-1

Privacy Statement
Press Release
Contact