TM 9-2350-277-20-4
ADJUST RAMP LOCK (M1064A3 ONLY) — Continued
0523 00
NOTE
The steps below are for one side of ramp lock adjustment. Adjust both sides of carrier at the
same time.
11. Loosen locknut (11) on forward clevis (8).
NOTE
Making linkage shorter pulls the ramp in and puts a tight squeeze on the ramp seal. Making
linkage longer lessens the squeeze on the seal.
12. Turn rod (6), as needed, to make sure ramp seal is compressed right. Tighten locknut (11) on clevis (8).
13. Lower ramp (see your -10). Return lever (4) to closed position.
0523 00-3
14. Remove two screws (12) and lockwashers (13) from trip plate (14). Discard lockwashers.
