TM 9-2350-277-20-4REPLACE TORSION BAR — Continued 0413 00INSTALLATIONCAUTIONWhen removing or installing torsion bars, the index or missing tooth on the anchor end oftorsion bar must align with index on spline in road wheel arm, to allow bar to pass through.CAUTIONAlign index or missing tooth on end of torsion bar with index on road wheel arm and torsionbar anchor before installing.CAUTIONHandle torsion bar with care. Do not tear or cut wrapping.NOTELeft and right torsion bars are not interchangeable. To determine correct bar, place arrow onend of torsion bar outboard, with arrow at top. Arrow must point toward front of carrier.1. Thread puller with adapter and screw into torsion bar.2. Install torsion bar (1) through road wheel arm (2) and anchor (3). (H) Guide torsion bar into anchor to ensure properalignment. Use slide hammer on puller to seat torsion bar.3. Remove puller and adapter from torsion bar.4. Put a light coat of grease on threads of plug (4). Install plug in road wheel arm (2).5. TIGHTEN PLUG (4) TO 50-75 LB-FT (68-102 N m) TORQUE. Use socket wrench attachment.0413 00-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
