ADJUSTMENT (cont) - TM-9-2350-277-20-4

REPLACE MORTAR HATCH INTERIOR RELEASE MECHANISMS (M1064A3 ONLY)

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
246

TM 9-2350-277-20-4 REPLACE MORTAR HATCH EXTERIOR CATCHES AND BUMPERS (M1064A3 ONLY) — Continued 0480 00 2. Adjust RIGHT exterior latch as follows: a. Open hatch sections. b. Loosen screws (1). Move bracket (2) to get 1/4 in (6 mm) between end of bracket (2) and edge of catch (3). c. If above adjustment cannot be made, loosen screws (4) and move catch (3) to get above measurement. d. Remove or install shims (5) between bumper (6) and door section so that tee head bolt (7) protrudes into catch (3) a distance of 9/16 to 3/4 in (14 to 19 mm) with center and right door sections firmly against bumper. e. Tighten screws (1) on bracket (2). f. TIGHTEN SCREWS (4) ON CATCH (3) AND TORQUE TO 360-420 LB-IN (41-47 N m). FOLLOW-THROUGH STEPS 1. Open and close mortar hatch covers (see your -10). Check that covers are properly installed. END OF TASK 0480 00-6

Privacy Statement
Press Release
Contact