REPLACE SHOCK ABSORBER - TM-9-2350-277-20-4

CHAPTER 16 UNIT MAINTENANCE INSTRUCTIONS FOR SHOCK ABSORBERS

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
109

TM 9-2350-277-20-4 REPLACE SHOCK ABSORBER 0435 00 THIS WORK PACKAGE COVERS: Removal (page 0435 00-1). Installation (page 0435 00-4). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Shock Absorber Tool (WP 0926 00, Item 67) Torque Wrench (WP 0926 00, Item 85) Materials/Parts Wiping rag (WP 0928 00, Item 65) Cotter pin (2) Outer seal Inner seal Personnel Required Unit Mechanic References See your -10 Equipment Condition Carrier on level surface Engine stopped (see your -10) Carrier blocked (see your -10) Track shroud and covers removed (WP 0438 00) Road wheel for respective shock absorber removed (WP 0426 00) REMOVAL 1. Remove blocks used to keep carrier from moving (see your -10). WARNING You can be hurt if road wheel lifter slips while road arm is being lowered. Stand clear. 2. Start engine (see your -10). Place range selector in RANGE 1. Slowly drive carrier forward off lifter. Remove lifter. WARNING Failure to set the parking brake and block the road wheels can allow the carrier to move and could result in injury or death. Always set the parking brake and block road wheels before working on the carrier. 3. Block carrier (see your -10). 0435 00-1

Privacy Statement
Press Release
Contact