TM 9-2350-277-20-2
REPLACE FUEL CONTROL SHAFT AND LINKAGE — Continued
0217 00
CAUTION
Use caution when removing linkage from pin due to spring on linkage.
5.
Remove nut (1) and washer (2) from linkage (3). Remove linkage (3) from pin (4).
6.
Remove locknut (5) and washer (6) holding bearing (7) to shaft (8). Discard locknut.
7.
Hold bearing (7) and remove screw (9) from bearing. Remove washer (10), lockwasher (11) and screw (9) from
bulkhead. Remove bearing (7) from shaft (8).
8.
Remove shaft (8) from bearing (12).
9.
Remove screw (13) from bearing (12). Remove bearing (12) from bulkhead. Remove washer (14), lockwasher (15) and
screw (13) from bulkhead.
10. Remove cotter pin (16), washer (17), and pin (4) from lever (18). Discard cotter pin.
0217 00-3
