TM 9-2350-277-20-2
REPLACE UPPER ACCELERATOR PEDAL ASSEMBLY — Continued
0216 00
4.
Secure pedal guide (1) to bulkhead with four washers (2) and screws (3).
5.
Install link (4) on lower accelerator pedal (5) and secure with pin (6), washer (7) and new cotter pin (8).
6.
Install screw (9), washer (10) and new locknut (11) on new throttle control arm (12). Do not tighten at this time.
7.
Install hand throttle pin (13) with cable (14) on throttle control arm (12) and secure with washer (15) and new cotter pin
(16).
8.
Install drag link (17) on throttle control arm (12) and secure with screw (18), two washers (19) and new locknut (20).
9.
Install throttle control arm (12) on shaft (21). Align arm with woodruff key. Hold nut (11) and tighten screw (9).
10. Install drag link (17) on fuel control shaft plate (22) and secure with screw (23), washer (24) and new locknut (25).
0216 00-4
