TM 9-2350-277-20-2
REPLACE FUEL CONTROL SHAFT AND LINKAGE
0217 00
THIS WORK PACKAGE COVERS:
Removal (page 0217 00-1).
Installation (page 0217 00-4).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Cotter pin
Locknut (7)
Lockwasher (2)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Trim vane lowered (see your -10)
Power plant front access door opened (see your -10).
Driver’s compartment power plant access panel
removed (see your -10)
Power plant front access cover removed (WP 0449 00)
Air intake elbow removed (WP 0173 00)
REMOVAL
1.
Remove spring (1) from bulkhead.
2.
Remove locknut (2), two washers (3) and screw (4) securing drag link (5) to throttle control arm (6). Discard locknut.
3.
Remove locknut (7), washer (8) and screw (9) securing drag link (5) to shaft (10). Remove drag link.
0217 00-1
