APU GEAR CASE: DISASSEMBLY, INSPECTION, REPAIR AND ASSEMBLY (CONTINUED)

APU GEAR CASE: DISASSEMBLY, lNSPECTION, REPAIR AND ASSEMBLY (CONTINUED) - TM-9-2350-267-34_281

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
249

12-10 Change 4 TM 9-2350-267-34 APU GEAR CASE: DISASSEMBLY, INSPECTION, REPAIR AND ASSEMBLY (CONTINUED) S Remove four screws (34) from adapter (32). T Install two 3/8-16 screws in adapter (32). U Alternately tighten 3/8-16 screws until adapter (32) is pushed free from chain housing (23). V Remove adapter (32). NOTE Remove studs (35) only if damaged. W Remove six studs (35). NOTE The remaining steps are the same for both sides of chain housing. X Remove four screws (36) from bearing retainer (37).

Privacy Statement
Press Release
Contact