APU GEAR CASE: DISASSEMBLY, lNSPECTION, REPAIR AND ASSEMBLY (Continued)

APU GEAR CASE: DISASSEMBLY, lNSPECTION, REPAIR AND ASSEMBLY (CONTINUED) - TM-9-2350-267-34_279

APU GEAR CASE: DISASSEMBLY, lNSPECTION, REPAIR AND ASSEMBLY (CONTINUED) - TM-9-2350-267-34_281

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
247

12-8 Change 4 TM 9-2350-267-34 APU GEAR CASE: DISASSEMBLY, lNSPECTION, REPAIR AND ASSEMBLY (Continued) Install mechanical puller (item 27, Appx D) on bushing (16). Tighten mechanical puller (item 27, Appx D) until drive sprocket (17) and bushing (16) are pulled from output shaft (18). Remove bushing (16), sprocket (17), chain (19), and key (20). Remove mechanical puller (item 27, Appx D) from bushing (16). NOTE Support generator pump and chain housing with block of wood to prevent units from dropping when last bolt is taken out. Lift engine from housing assembly. K Remove four screws (21) and four lockwashers (22) from chain housing (23). Discard lockwashers. L Remove chain housing (23) and gasket (24) with hydraulic pump (hidden) and generator (12) attached. M Discard gasket (24).

Privacy Statement
Press Release
Contact