Section II WINTERIZATION KIT COOLANT HEATER REPAIR

WINTERIZATION KIT: INITIAL INSTALLATlON (CONTINUED)

WINTERIZATION KIT, COOLANT HEATER REPAIR (CONTINUED) - TM-9-2350-267-34_233

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
201

WINTERZATION KIT: INITIAL INSTALLATION (CONTINUED) CAUTION H Fill radiator. NOTE To avoid coolant heater malfunction and possible failure, perform an air bleed on the winterization kit and engine coolant system Do not overdrain coolant system. As necessary, return drained after the kit has been installed, after reinstallation of the coolant heater, or after reinstallation of coolant lines. coolant to radiator, then continue air bleed procedure. Start engine and run it for a short period, observing flow of air and coolant F Before refilling radiator, disconnect winterization kit coolant hose at elbow from disconnected hose. A continuous flow of coolant without air bubbles on engine right bank coolant manifold. indicates that the air bleed is complete. G Temporarily plug open end of elbow and hold disconnected coolant hose end in a container. Section II WINTERIZATION KIT COOLANT HEATER REPAIR WINTERIZATION KIT: COOLANT HEATER REPAIR C D E F G H A Squeeze ends of clamp (1) with pliers. B Remove end of tube (2) from heater. Loosen screw (3) and locknut (4). Remove clamp (5) and tube (2). Loose four nuts (6). Turn end plate (7) clockwise. Remove end plate (7). Remove screw (8), lockwasher (9), locknut (10), lockwasher(11), and ground strap (12). 10-2.23/(10-2.24 blank) Change 4 TM 9-2350-267-34

Privacy Statement
Press Release
Contact