WINTERIZATION KIT: INITIAL INSTALLATlON (CONTINUED)

WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED) - TM-9-2350-267-34_229

Section II WINTERIZATION KIT COOLANT HEATER REPAIR

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
200

10-2.22 Change 4 TM 9-2350-267-34 WINTERIZATION KIT: INITIAL INSTALLATlON (CONTINUED) C Unfasted two winterization APU front air vent tarpaulin strap assemblies (190). Place strap assemblies inward and roll tarpaulin upward into smallest possible tube. Secure with webbing and chape assembly. D Unfasten top and side winterization APU side door and roof vent tarpaulin strap assemblies (191). Place both ends of strap assembly inward and roll tarpaulin downward into smallest tube possible until reaching next set of strap assemblies on sides of tarpaulin. Secure with two webbing and chape assemblies. E Open APU side door assembly and open door assembly on APU plenum assembly. Close APU side door assembly. CAUTION Winterization kit is not intended for use as a prime source of heat. Kit operation is intended to commence upon engine shutdown after engine temperatures have reached normal operating levels. Operation of the winterization kit with engine coolant temperature less than 0°F may result in failure of coolant heater.

Privacy Statement
Press Release
Contact