WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED)

WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED) - TM-9-2350-267-34_217

WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED) - TM-9-2350-267-34_219

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
188

10-2.10 Change 4 TM 9-2350-267-34 WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED) AN AO Place hose clamp (99) over end of 5/8 ID x 60-inch long coolant hose (100). Install hose on engine coolant pump inlet adapter (101) and tighten clamp. Install engine primary fuel filter-to-coolant heater fuel filter hose (102) on filter inlet elbow (71). AP AQ NOTE Secure hoses in steps AP and AQ to transmission with strap material using transmission screws and washers. Place coolant manifold hose (98) along the side and front of transmission and connect to the battery heater inlet tube. Trim hose to fit and install on heater inlet tube with hose clamp (103). Place coolant pump inlet hose (100) along front of transmission and connect to battery heater outlet tube (104). Trim hose to fit, and install on heater outlet tube with hose clamp (105).

Privacy Statement
Press Release
Contact