BILGE PUMP REPAIR (CONTINUED)ASSEMBLYABCDEFGHIJKConnect wire (44) to inside of end bell (40) with screw (42) andnew lockwasher (43).Install motor stator (45) and two gaskets (46) on end bell (40),making sure wire (41) goes through opening at top end of endbell (40).Install capacitor (37), two gaskets (38) and spacer (39) on endbell (40).Solder wire (41) to capacitor (37).Install four screws (35) and four lockwashers (36).Install bearing (26), end bell (14) and bearing (34) on motor ar-mature (25).Install new snapring (33), plate (32), four screws (30) and fourlockwashers (31).Install new lockwire (29).Install four studs (27) on end bell (14).Install four glass sleeves (28).Install end bell (14), motor armature (25), bearing (26), four studs(27) and four glass sleeves (28) as an assembly.LMNOPQRSTUInstall four new gaskets (24), four flat washers (23), four newlockwashers (22) and four nuts (21).Install three new shaft seals (20).Install new gasket (19), seal cover (18), four new lockwashers(17) and four screws (16).Install key (18).Install impeller housing (13) on end bell (14).Install impeller (12).Install new lockwasher (11) and nut (10) using lug (item 16,Appx D).Install inlet screen (8) and impeller cover (9) with four screws(6) and four flat washers (7).Install four screws (4) and four new lockwashers (5).Install four new brushes (3), four new preformed packings (2)and four brush cap assemblies (1).T A 3 1 2 5 7 0 9-5/(9-6 blank)Change 1TM 9-2350-267-34All data on pages 9-6 thru 9-8 deleted
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business