BILGE PUMP REPAIR (CONTINUED)HIJKLMNOPQRSTUPull impeller housing (13) from end bell (14).Remove key (15).Remove four screws (16), four lockwashers (17), seal cover (18)and gasket (19).Remove and discard three shaft seals (20).Remove four nuts (21), four lockwashers (22), four flat washers(23) and four gaskets (24).Remove end bell (14), motor armature (25), bearing (26), fourstuds (27) and four glass sleeves (28) as an assembly.Remove four glass sleeves (28).Remove four studs (27) from end bell (14).Remove and discard lockwire (29).Remove four screws (30), four lockwashers (31), plate (32) andsnapring (33). Discard snapring.Remove bearing (34), end bell (14) and bearing (26) from motorarmature (25).Remove four screws (35) and four lockwashers (36) fromcapacitor (37).Pull capacitor (37), two gaskets (38), and spacer (39) away fromend bell (40). Desolder wire (41) from capacitor (37).Remove capacitor (37), two gaskets (38) and spacer (39) fromend bell (40).V Remove screw (42) and lockwasher (43) to release wire (44) frominside of end bell (40).W Remove motor stator (45) and two gaskets (46) from end bell(40).INSPECTION AND REPAIRABCDEFGHClean and inspect inlet screen (8). Blow out mesh with com-pressed air. Replace if torn.Inspect impeller (12) for damage and defects. Smooth out nicksand burrs with soft stone or fine mill file. Replace if damagedor defective.Inspect impeller housing (13) for cracks, warped mating sur-face or other damage. Replace if damaged or defective.Inspect key (15) for damage. Replace if necessary.Inspect seal cover (18) for cracks, warped mating surface andother damage. Replace if damaged or defective.Inspect glass sleeves (28) for chips or breaks. Replace asnecessary.Inspect end bell (14) for cracks, defects and warped mating sur-faces. Replace if defective.Test motor armature (25) on growler. Replace if defective.TA3125689-3Change 1TM 9-2350-267-34
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
