VANE AXIAL COOLING FAN ASSEMBLIES REPAIR (CONTINUED)

INSPECTION AND REPAIR - TM-9-2350-267-34_117

VANE AXIAL COOLING FAN ASSEMBLIES REPAIR (CONTINUED) - TM-9-2350-267-34_119

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
94

5-22 Change 4 VANE AXIAL COOLING FAN ASSEMBLIES REPAIR (CONTINUED) TM 9-2350-267-34 I J K L M Check spacer (20) for cracks or distortion. Replace defective. spacer if Refer to TM 9-214 for inspection of bearings (18 and 30). Measure OD (F) of bearings (18). Replace bearings (18) if OD (F) is not 2.4404-2.4409 inches. Measure ID(G) of bearings (18). Replace bearings (18) if ID (G) is not 1.1807-1.1811 inch. Measure fit of bearings (18) to shaft (16). Fit should be 0.0004T- 0.0004L. N Replace key washer (27). O Measure OD(H) of bearing (30). Replace bring (30) if OD (H) is not 2.0467-2.0472 inches. P Measure ID (I) of bearing (30). Replace bearing (30) if ID (I) is not 0.9839-0.9843 inch. Q Measure fit of bearing (30) to shaft (29). Fit should be 0.0003T- 0.0008L.

Privacy Statement
Press Release
Contact