CANISTER DOOR LATCH ASSEMBLY (RIGHT SIDE) AND PERSONNEL SIDE DOOR: REMOVAL, DISASSEMBLY, ASSEMBLY ANDINSTALLATION (CONTINUED)REMOVALB Remove strike (13) and shims (14) from two door-mountedbrackets (15) by removing from each bracket, two screws (16),NOTEStwo flat washers (17) and two lockwashers (18). Discardlockwashers.Latch for personnel door is mounted on top halfof plate between right canister door and person-nel door. Procedures are identical.ASSEMBLYNote number and position of shims to ensure pro-A Install shims (14) and strike (13) on door-mounted bracketsper installation.(15) with two screws (16), two flat washers (17) and two newlockwashers (18).A Remove two latch assemblies (1) from plate (2) by removingfrom each, four screws (4) and four lockwashers (5). RemoveBInstall handle (12) on each latch (1) with new spring pin (1 1).and set aside shims (3). Discard lockwashers.INSTALLATIONB Remove plate (2) from vehicle hull by removing four screws (6),four flat washers (7) and four lockwashers (8). DiscardA Apply zinc chromate paste (item 46, Appx D) between matinglockwashers.surf ace of plate (2) or spacer (10) and vehicle hull.C For vehicles 34 and up only, remove three screws (9), releasingB On vehicles 34 and up only, install spacer (10) on hull withspacer (10) from hull.three screws (9).DISASSEMBLYcInstall plate (2) on hull or on spacer (10) with four screws (6),four flat washers (7) and four new lockwashers (8).A Remove spring pin (11) and handle (12) from each latch (l).Discard spring pin.D Install shims (3) and latch assemblies (1) on plate (2) with fourscrews (4) and four new lockwashers (5).9-45Change 1TA312945TM 9-2350-267-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
