HINGES, CANISTER DOORS AND PERSONNEL DOOR

canister doors hold-open latch and bumper assembly - TM-9-2350-267-20_971

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
893

HINGES, CANISTER DOORS AND PERSONNEL DOOR (VEHICLES 34 AND UP): REMOVAL, AND INSTALLATION REMOVAL NOTE Note number and position of shims to ensure pro- per installation. D Remove three screws (5), three flat washers (6), three lockwashers (7) and three nuts (8). Remove hinge assemblies (4) and shims (9) from vehicle hull. Discard lockwashers. INSTALLATION NOTE Hinge assemblies for canister doors and person- A Apply zinc chromate paste (item 46, Appx D) between mating nel side door are similar. The following procedures surf aces of hinge assemblies (4), shims (9), door (1) and vehicle hull. apply to all three hinge assemblies. A Open appropriate door (1). B Install hinge assemblies (4) and shims (9) with three screws (2) and (personnel door only) three new lockwashers (3). B Install sling on door (1). Attach hook of suitable lifting device. c Install hinge assemblies (4) and shims (9) on vehicle hull with Take up slack in sling to hold door taut. three screws (5), three flat washers (6), three new lockwashers (7) and three nuts (8). c Remove three screws (2) and (from personnel door only) three lockwashers (3) releasing hinge assemblies (4) from door (1). D Remove sling from door (1) and suitable lifting device. Discard lockwashers. E Close and secure appropriate door. 9-46.3/(9-46.4 blank) Change 1 TM 9-2350-267-20

Privacy Statement
Press Release
Contact