HYDRAULIC GAGE PANEL WIRING HARNESS (12333555): REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION
(CONTINUED)
REMOVAL
ASSEMBLY
A Disconnect wiring harness plug (1) from gage panel receptacle
Reassemble and regroup wires.
(2).
INSTALLATION
B Turn four retaining studs (3) and open cover (4).
A Install receptacle (2) and attached wires to gage panel assembly.
C Remove eight harness connectors (5) from gages (6), light (7)
and conveyor control switch (8).
B
Install four screws (9), four flat washers (10), four new
lockwashers (11) and four nuts (12).
D Remove four screws (9), four flat washers (10), four lockwashers
(11) and four nuts (12). Discard lockwashers.
C
Install eight harness connectors (5) to gages (6), light (7) and
conveyor control switch (8).
E Remove receptacle (2) and attached wires from gage panel
assembly.
D Close cover (4) and turn four retaining studs (3).
DISASSEMBLY
E Connect wiring harness plug (1) to gage panel receptacle (2).
Disassemble and replace defective wires (p 2-307).
TA57464
6-125
Change 2
TM 9-2350-267-20