NEUTRAL SAFETY SWITCH: REMOVAL, INSTALLATION AND ADJUSTMENT (CONTINUED)
.. —-. --- —— -- -——
ADJUSTMENT
A
Disconnect two electrical connectors (1).
B
Set transmission shift control lever in neutral (N) position.
C
Using a multimeter to check continuity, turn neutral safety
switch (2) until multimeter indicates 0 ohms - switch closed.
D Set transmission shift control lever to first gear. Multi-
meter must indicate Q - switch open.
E
Set transmission shift control lever to neutral (N) position.
Multimeter must indicate 0 - switch open. If not, repeat
steps C and D.
F
Set transmission shift control lever to every shift position.
Check multimeter indication at each position. Multimeter
must indicate ~ at positions 1, 2, 3, 4, R1 and R2, and
must indicate 0 ohms at N (neutral). If not, readjust.
INSTALLATION
Reverse removal procedures.
TA311048
6-17
TM 9-2350-267-20
