4-6
Change 1
TM 9-2350-267-20
FILLER NECK ASSEMBLY SEAL: REMOVAL AND INSTALLATION
h!!mumd
Materials/Parts:
Silicone compound (item 58, Appx D)
REMOVAL
A Open fuel fill access door (1).
B
Pull fuel fill cap (2) and chain (3) straight up and remove from
strainer (hidden).
C Remove eight screws (4), top washer (5), outer seal (6), inner seal
(7) and bottom washer (8) from around fuel fill neck (9).
INSTALLATION
A
B
c
D
E
F
G
H
I
NOTE
Seals are made eccentric so that they maybe ad-
justed. Filler neck may not be centered in filler
neck hole; adjust accordingly.
Apply silicone compound (item 58, Appx D) to both seals.
Place inner seal (7) inside outer seal (6). Turn seals to dine screw
holes.
Assemble top washer (5) on top, and position washer (8) with
threaded holes on bottom.
Insert eight screws (4) and turn three to four turns. Do not
tighten screws.
NOTE
Tightening or loosening of screws maybe required
during seal assembly installation.
Aline fuel fill neck (9) and seal assembly (10), and drive in
assembly with hammer.
After seal assembly (10) is installed, tighten eight screws (4).
Connect chain hook (3) and fuel fill cap (2) to strainer (hidden).
Screw fuel fill cap (2) into fuel fill neck (9).
Close fuel fill access door (1).
TA312729